Ive just installed one of the Sera Flore Active 1000 reactors on my ~950L tank. Its running inline on the output of an Eheim 2080 (running at full capacity, however it hasn't been cleaned in some time), with CO2 at around 5bps.
However, im noticing large bubbles emerging from the outlet within the tank, indicating that the CO2 is not dissolving completely. These bubbles appear in small 'burps' every 15-20 secs.
Has anyone come across this? Am I asking too much of the reactor by pushing 5bps through it? I'd greatly appreciate any advice or suggestions.