Aquarium Plants - Barr Report  
Go Back   Aquarium Plants - Barr Report > Barr Report > Estimative Index
Reload this Page need Ei Help...
Estimative Index *** Read Only ***

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
need Ei Help...
Old
  (#1 (permalink))
ziggy is Offline
Junior Poster
Poster
need Ei Help... - 06-09-2008, 12:22 PM

Can somebody point me in the direction for dosing macro nutrients recipe:

high fish load ... i think?
(5 bigger fish 5-6" approx. plec, 3 x clowns, 1 red tailed shark
40 approx. tetras)
275ltrs.
108 watts of light can add another 54watts if needed ?
co2 injection

(do i need to supply other info... i.e water hardness etc... )

i found this one on this site..... will it suit my needs...

60 – 80 Gallon Aquariums
+/- 3/4 tsp KN03 3x a week
+/- 3/16 tsp KH2P04 3x a week
+/- 1 tsp once a week (water change only) ( of what?).......
+/- ¼ tsp (15ml) Trace 3x a week
50% weekly water change

can somebody clarify +/- in this setup
  
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Old
  (#2 (permalink))
Gerryd is Offline
Lifetime Charter Member
Approaching Guru Status
Location: South Florida
06-09-2008, 11:31 PM

Hi,

Your fish load sounds okay now, but the redtail will get huge, not sure if you know that.

So you can go to about 2 watts per gallon. What type of lighting/bulbs are you using.

How are you injecting/mixing the c02 into the tank?

Are you using a drop checker with 4 or 5 kh solution to determine this?

Any and all water parms are good info to provide.

Quote:
60 – 80 Gallon Aquariums
+/- 1 tsp once a week (water change only) ( of what?).......

This is a GH booster, but not all use one. I do not. Depends on your water. You would only add this on the day you do the water change.

We also use Prime or an equivalent at a water change....

Give these threads a read:


EI light: for those less techy folks


The full version:
The Estimative Index of Dosing, or No Need for Test Kits

Hope this helps.


Gerry.
  
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Old
  (#3 (permalink))
VaughnH is Offline
Lifetime Charter Member
Approaching Guru Status
 
VaughnH's Avatar
06-10-2008, 04:45 AM

The +/- means, for example, 3/4 tsp, approximately. If you are using T5 lights, with good reflectors, you have about the right amount. But, you do need CO2 at about 30 ppm or so with that much light.


Hoppy
  
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Old
  (#4 (permalink))
ziggy is Offline
Junior Poster
Poster
06-10-2008, 11:20 AM

Code:
Your fish load sounds okay now, but the redtail will get huge, not sure if you know that.

My red tailed shark should only reach about 6" .... he's about 4" already... cant believe he was only the size of a small tetra when i got him

Code:
So you can go to about 2 watts per gallon. What type of lighting/bulbs are you using.

i have arcadia 4x54watts t5's 2 white / 2 blue at mo. i am using 2 white for plant growth, they are marine blubs, will be changing them as they expire over the next few months... any pointers as which bulbs to go for.?

Code:
How are you injecting/mixing the c02 into the tank?

i am injecting pressurized co2 into my eheim filter controlled via ph computer and ph probe.. set to ph of 7.05 based on kh of 11 = 29.400ppm

is there a benefit to to adding GH booster to my water changes.. i'm on the east london water supply... slightly hard water i think....


60 – 80 Gallon Aquariums
+/- 3/4 tsp KN03 3x a week
+/- 3/16 tsp KH2P04 3x a week
+/- 1 tsp once a week (water change only)
+/- ¼ tsp (15ml) Trace 3x a week
50% weekly water change

is a tsp roughly = 15gramms ( trying to figure out how much KN03 & KH2PNO4 to orded and how long it will last....)
  
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Old
  (#5 (permalink))
VaughnH is Offline
Lifetime Charter Member
Approaching Guru Status
 
VaughnH's Avatar
06-10-2008, 05:48 PM

The only way you can measure the amount of CO2 dissolved in the tank water, without spending over $1000, and with enough accuracy for the measurement to mean anything, is with a drop checker, as discussed in Drop Checkers/CO2 Indicators-Why and How. Don't be concerned about the tank water pH.

The lights you are using may be too far out of the range on color temperature to be fully effective for plants. It would be best to use bulbs with a color temperature rating between about 5500K to 10,000K, and, as you know, the actinic bulbs are not useful to plants.


Hoppy
  
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Reply



Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On

Points Per Thread View:
Points Per Thread:
Points Per Reply:



Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
LinkBacks Enabled by vBSEO 3.0.0 RC5


1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69