Squidly
03-30-2012, 06:20 PM
While adding a manifold to my Co2 setup, I managed to bend the section between my Scott regulator and Burket solenoid. What ever part this is (Swagelok 31GU?) doesn't seem up to the task having a small tube holding the two ends together (see photo). The purpose (I believe) originally was to extend the fitting past the regulator dial.
I would think there is a better way to facilitate this, perhaps using a bushing/nipple and reducer, but thought someone with more experience than I could come up with a better solution.
Thank you!
I would think there is a better way to facilitate this, perhaps using a bushing/nipple and reducer, but thought someone with more experience than I could come up with a better solution.
Thank you!